Threaded Connection: NPT or BSP threads — screws into female threaded fitting.
Hex Head or Round Head: Hex for wrench tightening; round for low torque applications.
Solid Forged Construction: No porosity — stronger than cast plugs.
ASTM A105: Forged carbon steel for high pressure service.
NPT Threads Standard: Tapered threads provide pressure-tight seal with PTFE tape.
Low Cost: Economical way to close small threaded ports.
 

Joins Two Pipes: Female threads on both ends — connects two threaded pipes.
Forged A105 Steel: High strength, no cast porosity.
Class 3000 / 6000: For high pressure hydraulic and steam service.
Hex or Round Coupling: Hex for easy wrenching; round for tight spaces.
Full Engagement Threads: Ensures full thread contact for maximum strength.
NPT or BSP: Both thread standards available.

Four Openings: Two on run, two on opposite branches — all butt weld connections.
Equal Cross: All four ports same size (standard).
Reinforced Intersections: Extra wall thickness at all three branch intersections.
ASTM A234 WPB: Carbon steel for moderate temperature.
Seamless up to 12″: Larger sizes fabricated from welded pipe.
Saves Space: One cross replaces two tees and a spool piece

Reducing Tee: Branch opening is smaller than the main run.
One Fitting Replaces Tee + Reducer: Saves welding and space.
Butt Weld Connections: Beveled ends on all three ports.
Reinforced Branch: Extra thickness at the reducing intersection.
ASTM A234 WPB: Standard carbon steel.
Any Run/Branch Combination: Custom size reductions available.

Equal Tee: All three openings are the same size.
Butt Weld Connections: Beveled ends for welding to main pipe and branch.
Reinforced Branch: Extra wall thickness at intersection for strength.
ASTM A234 WPB: Carbon steel for moderate temperature service.
Seamless up to 24″: One-piece construction for high integrity.
Full Pressure Rating: Branch rated same as run.

Eccentric Design: Offset taper — top flat or bottom flat installation.
Flat on Top (FOT): Prevents air pockets in horizontal liquid lines.
Flat on Bottom (FOB): Prevents sediment accumulation in horizontal solids lines.
Horizontal Liquid Lines: Standard for pump suction piping.
ASTM A234 WPB: Carbon steel for moderate temperature.
Beveled Both Ends: Ready for field butt welding.

Pipe End Closure: Used to permanently seal the end of a pipe.
Elliptical or Hemispherical Shape: Elliptical standard; hemispherical for higher pressure.
Butt Weld Connection: Beveled end for direct welding to pipe.
ASTM A234 WPB: Standard carbon steel for moderate temperature service.
Hydrostatic Test Pressure Capable: Designed to full pipe pressure rating.
Traceable: Heat number stamped on each cap.

90° Bend Angle: Standard fitting for turning pipelines at right angles.
Long Radius (1.5D): Standard for most applications — lower pressure drop.
Short Radius (1.0D): Compact option for tight spaces (e.g., equipment nozzles).
Seamless up to 24″: One-piece construction for high integrity.
Beveled Ends: ASME B16.25 bevel for easy butt welding.
3D / 5D Bends Available: Long radius bending for large diameter pipelines.

Three-Piece Design: Two threaded ends + center nut — allows pipe disconnection.
Forged A105 Steel: High strength for pressure retaining service.
Class 3000 / 6000: Full pressure rating in removable design.
Metal-to-Metal or Gasket Seat: Choose based on sealing requirement.
Easy Maintenance: Disconnect pipes without unthreading from pipe ends.
NPT or BSP Threads: Both standards available.